Polystyrene frame for 100 cm indirect corner LED lighting - Veil effect - K14114

Polystyrene frame for indirect lighting with the possibility of housing 2 LED strips to reproduce in a simple, practical but above all economical way, elegant and refined plays of light through the illumination of walls and ceilings.

This solution is the best alternative to classic plasterboard ceilings. Thanks to its sophisticated design, you can illuminate your walls or room roofs in a unique style.

Our models of decorative compact polystyrene mouldings are made of D30 high-density expanded polystyrene, with well-finished details and edges. They are fully customisable, easy to cut to suit your needs, and can also be plastered and painted. 

It is also possible to install them outdoors.

The installation of the decorative frame is simple and practical for all DIY enthusiasts and do-it-yourselfers, even the less experienced. They can be installed using a special adhesive (not included) and therefore do not require the use of dowels and screws.

The LED strip should always be installed inside an aluminium profile to dissipate heat. The profile must then be installed inside the polystyrene frame. It is therefore not possible to fix the LED strip directly onto the surface of the frame as the LED strip would be damaged in a short time due to overheating, which would invalidate the warranty of the LED strip.

The aluminium profile, LED strip and glue for installation are not included!

DATA SHEET:

Bezel length: 1000mm

Dimensions: 95mm x 95mm

Profile housing for LED strip: 17 mm

Installation: Corner Ceiling/Wall

Paintable: Yes

Stuccoable: Yes

Can be installed outdoors: Yes

Material: High Density Polystyrene D30