PIR SENSORS INSIDE PROFILE 12-24V 3A DIR04

Thanks to its very small size, this motion/compression sensor can be fitted inside the aluminium profiles of LED bars.

This pir sensor is equipped with a controller with the possibility of adjusting the light intensity and switch-off delay.

Maximum power consumption 3A

SWITCH-OFF DELAY

1.Disconnect and re-connect the power supply and press the button 1 quick time to enter the configuration mode, the Blue light will make 2 quick flashes.

2. Press the button once fast and the light will do a number of flashes according to the indicated:

Blue light 1 flash=8s / 2 flash=35s / 3 flash=60s / 4 flash=180s / 5 flash=300s / 6 flash=600s

STANDBY BRIGHTNESS SETTING

Press the button once long enough for the White lamp to light up and make a sequence of flashes:

White light

1 flash= OFF-100% / 2 flash= 3%-100% / 3 flash= 10%-100% / 4 flash= 20%-100% / 5 flash= 40%-100%

Once set release and wait 5sec to store

DIURNAL SENSOR

Hold down the button and give power: Light sensor on/off, with the light sensor on the lamp will only light up when the room is dark, remaining off in daylight.